Odyssey Li-Cor Model 9120 Infrared Imaging System

Odyssey Li-Cor Model 9120 Infrared Imaging System

**This item was tested as far as we could. We don't have the software to fully test this instrument. Unit powers on without errors. Unit has slight cosmetic blemishes from normal use. See photos for details.

The Odyssey System provides a flexible, multifunctional platform to accommodate a variety of applications, so you get results faster. One example is the In-Cell Western assay, an immunocytochemical technique performed with cultured cells in microtiter plates. This assay uses target- specific antibodies to quantify protein levels in fixed cells. Accuracy, reproducibility, and throughput are all increased by eliminating time-consuming, error prone steps such as lysate preparation and gel electrophoresis.

Wide Range of Applications

IRDye Infrared Dye secondary antibodies and conjugates are optimized for a wide variety of applications, including:

• Western Blots: Two-color and In-Gel
• Cell-based Assays: In-Cell Westerns and On-Cell Westerns 
• Protein Detection: Coomassie Stained Gels, Membrane and Slide Arrays
• Imaging: In Vivo, Whole Organ and Tissue Section 
• Nucleic Acids: Mobility Shift Assays, DNA Gel Staining, Arrays 
• Microwell Assays: ELISA/FLISA, Transcription Factors, Protein Arrays

 Specifications

 Laser/Microscope
Laser Lifetime: 40,000 hours typical.
700 Channel Laser Source: Solid-state diode laser at 685 nm.
800 Channel Laser Source: Solid-state diode laser at 785 nm.
Detectors: Silicon avalanche photodiodes.
Scanning Speed: 5-40 cm/s.
Resolution: 21-337 µm.
Focusing: Scan bed is movable in the Z-dimension, allowing the fluorescence detection microscope to be aligned to the top surface of the glass to obtain the best signal-to-noise ratio.
Operating Conditions: For Indoor use only; operating temperature 15-35°C and dew point not greater than 19°C, non-condensing; altitude not to exceed 2000m.
Environmental Conditions: Pollution Degree 1.
Fuse Ratings: Fuses are non-user replaceable. A 5A fast blow fuse protects the Digital Signal Processor (DSP).
Power Requirements: Switched voltage selection between 100-127 VAC and 200-240 VAC (voltage fluctuations not to exceed 10% of the nominal voltage); 47-63 Hz; 1.1 A at 120V typical; 2.25A at 120V maximum (270W). Insulation Category II.
Data Storage Capacity: >25 GB.
Network Protocol: TCP/IP.
Network Connection: Cat. 5 RJ-45, 10Base-T/100Base-TX. Use only the supplied cable.