Waters Acquity Classic UPLC System w/ FLR Detector

Waters Acquity Classic UPLC System w/ FLR Detector

***Waters Acquity UPLC is preowned with slight wear from normal use, (right panel modules have light scratches, FLR Detector powers on with red error light, lamp may need to be replaced.)   System will need to be validated/calibrated to ensure accurate results. Inquire if validation/calibration is available for an additional cost. 30-day warranty included with purchase. See photos for details.

Includes:

• Binary Solvent Manager - 186015001
• Sample Manager - 800000227
• FLR Detector - 186015029
• Column Heater -186015010
• Solvent Rack

The Waters Acquity UPLC (Ultra Peformance LC) system provides you with reproducible, dependable and data rich results for challenging separations. This UPLC system features a wide range of flow rates, back pressures and linear velocities, with increased throughput with high efficiency so you get the most for your time and resources. This contained tower uplc system holds a sample manager, column heater, binary solvent manager, and detector. This ultra-performance liquid chromatography system has a unique sub 2 μm particle system that offers 3 times the efficiency of a 5 μm system with 70% higher resolution. This higher resolution means more information from more samples in less time. The Waters UPLC sytem can then run separations at a flow rate 3 times faster than HPLC, without a loss in resolution. This Aquity system contains a  Detector, sampler manager autosampler, a binary solvent manager, as well as a solvent and waste tray. 

Binary Solvent Manager 

• The binary solvent manager is a high-pressure pump that moves solvent through the system. It provides steady (pulse-free) solvent flow at analytical flow rates. The binary solvent manager delivers solvent at flow rates of 1 mL/min at 103,421 kPa (1034 bar, 15,000 psi) and up to 2 mL/min at reduced pressures to 62,053 kPa (621 bar, 9000 psi). The binary solvent manager can pump two solvents simultaneously.

Sample Manager 

• The ACQUITY UPLC sample manager injects the samples it draws from microtiter plates or vials onto the chromatographic column. A locating mechanism uses a probe to access sample locations and draw sample from them. In the needle overfill load-ahead mode, the sample manager can perform an injection in approximately 15 seconds. The first injection requires additional overhead time.
  The sample manager accepts standard ANSI/SBS footprint plates, 5.03 ±0.02 inch × 3.365 ±0.02 inch, that conform to ANSI standards (maximum height = 2.2 inches, including covers). You can program any combination of these plates and vial holders for automated sample processing. Samples are loaded into the sample manager via the front door or the optional sample organizer, which transfers samples back and forth between the two instruments. The sample manager can maintain samples at any temperature between 4 and 40 ºC (39.2 to 104 ºF) in 25 ºC (77 ºF) or less ambient conditions.

FLR Detector 

The ACQUITY UPLC Fluorescence (FLR) Detector is a high-sensitivity, multi-channel fluorescence detector optimized for UPLC/UHPLC separations.

• Innovative flow cell design, low-noise electronics, and support for high-speed data
• Advanced optical design reduces light scatter, allowing for maximum light throughput and optimum signal-to-noise performance
• Low-volume flow cell increases opportunity for light absorption and enhances sensitivity